
MBus1005-USB
Connects MBus water or heat meters to a PC or USB-equipped gateway for reading and commissioning. It supports the listed CJ188 and EN1434 standards and uses USB 5 V power.
Find the right connection between field interfaces and system protocols.
Filters use documented product information. Unspecified capabilities are excluded. Confirm protocol roles, device models, point counts and site conditions before ordering.
Select a condition to remove it. Multiple protocols still require an AND match.

Connects MBus water or heat meters to a PC or USB-equipped gateway for reading and commissioning. It supports the listed CJ188 and EN1434 standards and uses USB 5 V power.

Provides four RS485 channels through a USB connection for PC-side multi-node acquisition and commissioning. It uses USB 5 V power without a separate external supply. Provides 4 serial ports.

Transparently links a HART instrument bus with isolated RS485 so a host or serial device can read and write HART slaves in point-to-point or multidrop configurations.
Connects an RS232 device to an RS485 bus using an external DC 12–24 V supply and automatic baud-rate adaptation for serial-interface conversion.

Provides bidirectional transparent transport between KNX TP and RS485 for host, HMI or gateway access to lighting and building sensors or actuators.

Converts the HBS F1/F2 connection on a Daikin VRV communication board to RS485 for host or serial-gateway access to the air-conditioning equipment.

Connects meter MBus wiring to RS485 through five MBus terminal groups, allowing a host or serial device to access field meters.

Splits one RS485 connection into two RS485 branches with optoelectronic isolation and signal regeneration for half-duplex serial networks requiring isolated branches or extension.